129
• If a caller leaves a very long message, part of it may
be lost when the system disconnects the call after
the maximum recording time you have set.
• If the caller pauses for longer than seven seconds,
the system stops recording and disconnects the call.
• If the system’s memory becomes full during
a message, the system stops recording and
disconnects the call.
• If the caller’s voice is very soft, the system may stop
recording and disconnect the call.
• Press VOLUME
to increase the telephone base
speaker volume.
• Press VOLUME
volume on a handset.
System does not answer after the correct number of
rings.
• Make sure that the answering system is on.
ANS ON should show on the handset and the
/ANSWER ON/OFF light on the telephone base
should be on.
• If toll saver is activated, the number of rings changes
to two when you have new messages stored.
• If the memory is full or the system is off, the system
will answer after ten rings.
• In some cases, the answering system is affected by
To Next Page
Loading...
