VTech A2210-NS User Manual

5
Voicemail voltage detection
There are 3 options to set the voicemail voltage detection on the telephone base.
To disable the voicemail voltage detection:
Remove the faceplate and overlay if they are on the telephone base. Then remove the sticker on the telephone base.
Use a narrow object to unplug all the jumpers from the telephone base.
Place the sticker back in place.
To set the voicemail voltage detection by the periodic low voltage pulse detection method:
Remove the faceplate and overlay if they are on the telephone base. Then remove the sticker on
the telephone base.
Use a narrow object to unplug all the jumpers from the telephone base. Then plug the jumpers into
1
,
2
and
3
.
Place the sticker back in place.
To set the voicemail voltage detection by the steady high voltage and periodic high voltage
pulse detection method:
Remove the faceplate and overlay if they are on the telephone base. Then remove the sticker on
the telephone base.
Use a narrow object to unplug all the jumpers from the telephone base. Then plug the jumpers into
1
,
2
and
4
.
Place the sticker back in place.
Speed Dial keys
There are up to 10 programmable guest-service (Speed Dial) keys. Program these keys to automatically dial telephone numbers or
to activate telephone system features.
To program a Speed Dial key:
Remove the faceplate and overlay if they are on the telephone base. Lift the handset, then press the recessed PROGRAM key.
The MUTE key ashes when in administrator mode.
Press the desired Speed Dial key where the telephone number is to be stored. You hear 3 beeps.
Enter the telephone number (up to 16 digits).
To insert a pause in the stored number, press the recessed PAUSE key.
The telephone stores the number automatically when 16 digits are entered. When the number has less than 16 digits, press the
recessed PROGRAM key again. You hear 3 rising beeps as conrmation.
To clear the programmed Speed Dial key:
Remove the faceplate and overlay if they are on the telephone base. Lift the handset, then press the recessed PROGRAM key.
The MUTE key ashes when in administrator mode.
Press the Speed Dial key where the telephone number is to be deleted. You hear 3 beeps. Press the recessed PROGRAM key
again. You hear 3 rising beeps as conrmation.
1.
2.
3.
1.
2.
3.
1.
2.
3.
1.
2.
3.
•
4.
1.
2.
Jumper
1 2 3 4

VTech A2210-NS Specifications

Power

power requirement	Line powered 24V or 48V
message waiting signal	Steady/periodic high voltage pulse or periodic low voltage pulse

Memory

speed dial memory locations	up to 10
speed dial memory digits	up to 16

Weight and Dimensions

telephone base size	8.03 x 5.98 x 3.74 in (204 x 152 x 95 mm)
corded handset size	8.39 x 1.85 x 1.58 in (213 x 47 x 40 mm)