VTech A2210-NS User Manual

6
Receive a call
When there is an incoming call, the telephone rings and the MESSAGE WAITING LED ashes.
To answer a call:
Lift the corded handset from the telephone base.
Place a call
Lift the corded handset. Listen for a dial tone and then dial the desired number, or press a Speed Dial key to dial a
programmed number.
End a call
Place the corded handset in the telephone base.
Share a call
During a call, parallel telephones (telephones on the same line) can join the call.
To join a call:
During a call, lift the corded handset to join.
Volume
Listening volume and ringer volume can be adjusted from the telephone base.
To adjust the listening volume:
During a call, press +/VOLUME or -/VOLUME to adjust the listening volume. The next call returns to the default listening volume.
To adjust the ringer volume:
At any time, slide the RINGER VOL switch on the right side of the telephone base to adjust the ringer volume.
Call waiting
When you hear a call waiting tone during a call, press FLASH on the telephone base to put your current call on hold and take
the new incoming call.
Press FLASH or the switch hook once rapidly at any time to switch back and forth between calls.
Mute
To mute the microphone:
During a call, press MUTE on the telephone base. The MUTE key illuminates when the mute function is turned on. You can hear
the party on the other end but they cannot hear you.
Press MUTE again to resume the conversation. The light on the MUTE key turns off.
1.
2.
1.
2.
Telephone operation

VTech A2210-NS Specifications

Power

power requirement	Line powered 24V or 48V
message waiting signal	Steady/periodic high voltage pulse or periodic low voltage pulse

Memory

speed dial memory locations	up to 10
speed dial memory digits	up to 16

Weight and Dimensions

telephone base size	8.03 x 5.98 x 3.74 in (204 x 152 x 95 mm)
corded handset size	8.39 x 1.85 x 1.58 in (213 x 47 x 40 mm)