Check for reception strength and camera angle before drilling the holes.
The types of screws and anchors you need depend on the composition of the wall. You may need to purchase
the screws and anchors separately to mount your camera units.
1. Place the wall mount bracket on a wall and then use a pencil to mark two holes in parallel. Remove the wall
mount bracket and drill two holes in the wall (7/32 inch drill bit).
2. If you drill the holes into a stud, go to step 3.
If you drill the holes into an object other than a stud, insert the wall anchors into the holes. Tap gently on
the ends with a hammer until the wall anchors are flush with the wall.
3. Insert the screws into the holes and tighten the screws until only 1/4 inch of the screws are exposed.
To Next Page
Loading...
Need help?
General
