4. Place the camera unit on the wall mount bracket, and then slide it forward until it locks into place. Align the
holes on the wall mount bracket with the screws on the wall, and slide the wall mount bracket down until it
locks into place.
5. You can maximize your camera unit’s viewing angles by tilting the wall mount bracket. Hold the camera unit,
and then rotate the knob in anticlockwise direction. This will loosen the joint of the wall mount bracket. Tilt your
camera unit up or down to adjust to your preferred angle. Then, rotate the knob in clockwise direction to tighten
the joint and secure the angle.v
To Next Page
Loading...
Need help?
General
