VTech CareLine User Manual

3
Handset charger installation
Electrical outlet
not controlled by
a wall switch
Handset charger
power adapter
Install the charger
as below.
1. Place the handset in
the handset charger
to charge.
2.
Handset battery charging
Once you have installed the battery, the handset indicates
the battery status. If necessary, place the handset in the
handset charger to charge. The battery is fully charged
after 11 hours of continuous charging.
Battery indicators Battery status Action
The screen is blank,
or displays Place
in charger and
ashes.
The battery has no
or very little charge.
The handset cannot
be used.
Charge without
interruption (about
30 minutes).
The screen displays
Low battery and
ashes.
The battery has
enough charge to be
used for a short time.
Charge without
interruption (about
30 minutes).
The screen displays
HANDSET X.
The battery is
charged.
To keep the
battery charged,
place it in the
handset charger
when not in use.

VTech CareLine Specifications

Frequency and Channels

frequency control	Crystal controlled PLL synthesizer
transmit frequency	1921.536-1928.448 MHz
channels	5

Power

handset power requirement	2.4V Ni-MH
charger power requirement	6V AC @ 300mA

Memory

handset directory memory locations	50
handset directory memory digits	up to 30 digits
handset directory memory characters	15 characters
handset caller ID log memory locations	50
handset caller ID log memory digits	up to 24 digits
handset caller ID log memory characters	15 characters