VTech CS6124 Quick Start Guide

1
Quick start guide (Canada edition)
CS6124/CS6124-11/CS6124-2/
CS6124-21
Introduction
This quick start guide provides you with the basic installation
and use instructions. A limited set of features are described in
abbreviated form.
Please refer to the user’s manual for complete installation and
operation instructions.
Telephone base and charger installation
Install the telephone base and charger as shown below.
Use only the power adapter(s) and battery(ies) supplied with
this product.
Battery installation and charging
Install the battery as shown below. Once you have installed the
battery, you may be able to make and receive short calls. For
best performance, charge the handset battery continuously for at
least 16 hours.
CHARGE light
remains on
when charging.
1
Plug the battery connector
securely into the socket.
2
Place the battery with the
wires inside the battery
compartment.
3
Slide the battery
compartment cover towards
the center of the handset
until it clicks into place.
4
Charge the handset in the
telephone base or charger.
Telephone base
Telephone
line cord
Electrical outlet
(not controlled by
a wall switch)
Telephone
wall jack
A DSL lter
(not included)
is required if
you have DSL
high-speed
Internet service
Telephone base
power adapter
Charger
Charger
adapter

VTech CS6124 Specifications

Frequency and Channels

transmit frequency handset	1921.536-1928.448 MHz
transmit frequency telephone base	1921.536-1928.448 MHz
channels	5

Power Requirements

handset battery	2.4V Ni-MH battery
telephone base power	6V AC @ 300mA
charger power	6V AC @300mA

Memory

handset directory memory locations	30 memory locations
handset directory memory capacity	up to 30 digits and 15 characters
handset call log memory locations	30 memory locations