VTech CS6128-31 - Set Telephone Base RNger; Set Remote Access Code

www.vtechphones.com
40
Answering system
Set telephone base ringer
This feature allows you to select the telephone base ringer volume level. You
can choose from HI (high), OF (off) or LO (low).
Press SET UP when the phone is not in use, until the system announces the
telephone base ringer setting.
Press /SKIP or /REPEAT until the system announces the desired telephone
base ringer volume level, then press SET UP to save and go to the next setting,
or press /PLAY/STOP to save and exit set up mode.
Set remote access code
A two-digit security code is required to access the answering system remotely
from any touch tone telephone. The preset code is 19. You can set the code
from 10 to 99.
To set the remote access code:
Press SET UP when the phone is not in use, until the system announces the
remote access code setting.
Press /SKIP or /REPEAT to change the remote access code by one, or press
and hold /SKIP or /REPEAT to advance or decrease by increments of 10.
Press SET UP to save and go to the next setting, or press /PLAY/STOP to
save and exit set up mode.
1.
2.
1.
2.
The handset
ringer volume is
set separately.
See page 7 for
details.
•