VTech CTM-S2421 User Manual

68
SIP contemporary trimstyle 2-line - S2320/S2320-6VDC
Telephone operation
Receive a call
When there is an incoming call, the telephone rings and the corresponding line key ashes.
To answer a call:
Press the ashing line key, or press /SPEAKER to pick up the ringing line. The respective line key illuminates when the phone line
is in use. The /SPEAKER key illuminates when in speakerphone mode.
Place a call
Press LINE 1, LINE 2 or /SPEAKER. Listen for a dial tone and then dial the desired number. The respective line key illuminates
when the phone line is in use. The /SPEAKER key illuminates when in speakerphone mode.
End a call
Press OFF or place the handset back in the telephone base. The call ends when all handsets hang up.
Share a call
During a call on line 1 or line 2, another handset can join the call by pressing the respective line key or /SPEAKER.
Speakerphone
During a call, press /SPEAKER to switch between speakerphone mode and handset earpiece mode.
When the telephone is idle, press /SPEAKER. The rst available line is selected, starting with line 1.
Redial
The last dialed number is stored for 15 minutes.
To redial the last dialed number:
Press LINE 1, LINE 2 or /SPEAKER. Listen for a dial tone. Then press REDIAL.
Volume
Listening volume can be adjusted on the handset.
To adjust the listening volume:
During a call on the handset, press -/VOLUME/+ on it to adjust the listening volume. The next call returns to the default
listening volume.
Call waiting
Call waiting supports 2-line phones congured as single SIP account only. To change the SIP account settings, refer to the
SIP Phone Conguration Guide for details.
When you hear a call waiting tone during a call, press the corresponding line key to put the current call on hold and take the new
incoming call.
Press the corresponding line key at any time to switch back and forth between calls.
Message waiting indicator (only for line 1)
When a voice message is received, the MESSAGE WAITING LEDs on the main telephone base and handsets ash.
Mute
To mute the microphone:
During a call, press MUTE. The MUTE light turns on when the mute function is turned on. You can hear the party on the other
end but they cannot hear you.
Press MUTE again to resume the conversation. The MUTE light turns off.
Hold
To place a call on hold:
During a call, press HOLD. The corresponding line key ashes when the call is on hold.
Press the ashing line key or /SPEAKER to release the call from hold, or the call will end automatically after the preset call on
hold duration. When both lines are on hold, press /SPEAKER only releases the call from hold on line 1.
1.
2.
1.
2.
1.
2.

VTech CTM-S2421 Specifications

General

Brand	VTech
Model	CTM-S2421
Category	Cordless Telephone
Language	English