Status check
After you power on both your baby unit and parent unit, the power light of baby unit turns on.
If the parent unit is out of range of the baby unit, or the baby unit is out of power, the parent unit beeps and its LCD displays NOT LINKED.
Move the parent unit closer to the baby unit.
Make sure the baby unit is powered on.
Positioning the baby monitor
Note: This audio monitor is intended as an aid. It is not a substitute for proper adult supervision, and should not be used as such.
Keep the baby unit out of the reach of your baby. Never place or mount the baby unit inside the baby’s crib or playpen.
Caution:
The default speaker volume of your parent unit is level 3. If you experience high-pitched screeching noise from your baby monitor while positioning:
Make sure your baby unit and parent unit are more than 6.5 feet (2 meters) apart, OR
Turn down the volume of your parent unit.
To Next Page
Loading...
