Getting started
5
Headset charging
After installing the telephone base, charge the headset as shown below. The
headset is fully charged after three hours of continuous charging. If the light does
not turn on while charging, you need to charge the headset without interruption for
at least 15 minutes to give the headset enough charge to use for a short time. For
best performance, keep the headset in the telephone base when not in use. See the
table on page 84 for battery operating times.
Place the tip of the headset in the small cradle on the telephone base.1.
The magnet holds the top of the headset in place. The light turns on
when charging.
2.
The light
To Next Page
Loading...
Need help?
General
