14
Getting started
System setup
Prime line
Use this feature, also known as automatic line selection, to choose which line is
automatically selected each time you make an outside call. If you select Auto,
the deskset picks up any plugged telephone line starting from Line 1.
To set the prime line:
1. When the telephone is idle, press MENU/SELECT.
2. Press or to scroll to System Setup, then press
MENU/SELECT or /SKIP.
3. Press or to scroll to Prime Line, then press
MENU/SELECT or /SKIP.
4. Press or to choose the desired line, then press
MENU/SELECT or /SKIP. To exit without making
changes, press CANCEL.
NOTE: If you install less than four telephone line cords to
the UP416 console and select Auto as your Prime line
setting, make sure you plug in your telephone line cords
starting from L1/2 jack. Avoid having any unoccupied
telephone jack between other occupied telephone jacks.
One Touch
Phone Settings
>System Setup
Registration
System Setup
Set Ext No.
>Prime Line
Network Setup
Prime Line
Line 3
Line 4
>Auto
To Next Page
Loading...
Need help?
General
