VTech InnoTab3 - Getting Started with InnoTab 3; Stylus and Battery Setup

4
4
Slide this switch to open the battery doors.
Always replace the InnoTab
®
3 battery doors
after changing batteries.
microSD Card Slot Insert a microSD memory card (not included).
(NOTE: InnoTab
®
3 is compatible with microSD
memory cards up to 32GB.)
Battery Compartments Insert 4 "AA" batteries (not included) or the
rechargeable battery packs. For battery
installation instructions, please see the section
below.
How to Attach the Stylus
Tie one end of the stylus string to the stylus and the other end to the stylus
fastener on the InnoTab
®
3.
Installing the Rechargeable Battery Packs
1. Make sure the InnoTab
®
3 is turned off.
2. Turn the unit over. Slide the battery door lock switch forward and push
the battery covers off to each side to remove them.
3. Insert Battery PackƗ into the compartment on the right side and Battery
PackƘ into the compartment on the left side.
 d$GL>KMMA>;:MM>KRI:<DBGMHMA><HGG><MHKLEHM?BKLM
 d/A>GIK>LLMA>;:MM>KRI:<D=HPGNGMBEBMK>LMLBGIE:<>
 ->IE:<>MA>;:MM>KR<HO>KL
Battery Door Lock Sliding
Switch
G
E
T
T
I
N
G
S
T
A
R
T
E
D
Case: 1:15-cv-10889 Document #: 73-1 Filed: 05/18/16 Page 8 of 41 PageID #:925