VTech Learn & Discover Driver - Getting Started; Battery Installation

33
INCLUDED IN THIS PACKAGE
- One VTech
®
Learn & Discover Driver
TM
- One user’s manual
WARNING: All packing materials, such as tape, plastic sheets, packing
lockers, wire ties and tags are not part of this toy, and
should be discarded for your child’s safety.
ATTENTION: Pour la sécurité de votre enfant, débarrassez-vous de
tous les produits d’emballage tels que rubans adhésifs,
feuilles de plastique, attaches et étiquettes. Ils ne font
pas partie du jouet.
NOTE: Please keep user’s manual as it contains important
information.
Unlock the packaging locks:
Rotate the packing locks
90 degrees counter-clockwise.
Pull out the packing locks.
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
bottom of the unit. Use a coin or a
screwdriver to loosen the screw.
3. Install 2 new ‘AA’ batteries following
the diagram inside the battery box.
(The use of new alkaline batteries is
recommended for maximum performance.)
Getting Started