What’s in the box
Important safety instructions
The applied nameplate is located at the bottom of the baby unit’s base.
When using your equipment, basic safety precautions should always be followed to reduce the risk of fire, electric
shock and injury, including the following:
1. Follow all warnings and instructions marked on the product.
2. Adult setup is required.
3. CAUTION: Do not install the baby unit at a height above 2 metres.
4. This product is not a substitute for adult supervision of the infant. Supervising the infant is the parent’s or
caregiver’s responsibility. This product could cease operating, and therefore you should not assume it will
continue working properly for any given period of time. Further, this is not a medical device and should not be
used as such. This product is intended to assist you in supervising your baby.
5. Do not use this product near water. For example, do not use it next to a bath tub, wash bowl, kitchen sink,
laundry tub or swimming pool, or in a wet basement or shower.
6. Use only the adapter included with this product. Incorrect adapter polarity or voltage can seriously damage the
product.
Baby unit power adapter: Output: 5V DC 1000mA.
7. The power adapter is intended to be correctly oriented in a vertical or floor mount position. The prongs are not
designed to hold the plug in place if it is plugged into a ceiling, under-the-table or cabinet outlet.
8. For pluggable equipment, the socket-outlet (power adapter) shall be installed near the equipment and shall be
To Next Page
Loading...
Need help?
General
