Mount the baby unit (optional)
NOTES:
Check for reception strength and baby unit angle before drilling the holes.
The types of screws and anchors you need depend on the composition of the wall. You may need to purchase
the screws and anchors separately to mount your baby units.
1. Place the wall mount bracket on a wall and then use a pencil to mark two holes in parallel. Remove the wall
mount bracket and drill two holes in the wall (7/32 inch drill bit).
2. If you drill the holes into a stud, go to step 3.
If you drill the holes into an object other than a stud, insert the wall anchors into the holes. Tap gently on the
To Next Page
Loading...
