2. Slide the switch to ON to power on your baby unit.
NOTE: Camera lens and surface may get warm during normal operation.
Before use
Pair a new baby unit
Each newly purchased baby unit (RM724HD) must be paired to your system (RM5764HD/RM7764HD).
NOTE:
You can pair an additional baby unit to your parent unit. New baby unit must be paired to the parent unit before
use.
Make sure you power on the parent unit before pairing.
1. Press MENU when the parent unit is idle.
2. Go to > Add camera, then press SELECT or to continue.
3. Follow the instructions shown on screen to add the baby unit. When the baby unit is successfully added to your
parent unit, the parent unit displays the live video.
Test the location for the baby unit
If you plan to install your baby unit in a designated location, and use your home Wi-Fi network to connect your video
monitor, you need to test which of your selected monitoring areas within the house have good Wi-Fi signal strength.
After you have powered on your parent unit, you can use your parent unit’s Wi-Fi signal strength indicator to assist in
checking. Once you have identified the suitable location, you can install your baby unit. Adjust the distance between
your baby unit and the Wi-Fi router if needed.
TIP:
Depending on surroundings and obstructing factors, such as the effect distance and internal walls have on signal
strength, you may experience reduced Wi-Fi signal. To improve the Wi-Fi signal strength, adjust the distance or
direction of your parent unit. Check with your parent unit again.
To Next Page
Loading...
Need help?
General
