3
Rotate the packaging locks 90 degrees
counterclockwise.
Pull out the packaging locks and discard.
Unlock the Packaging Locks
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the bottom of the unit, use
a screwdriver to loosen the screws, and then open the battery
cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 6 new AA (AM-3/LR6) batteries
following the diagram inside the battery box.
(For best performance, alkaline batteries
or fully charged Ni-MH rechargeable
batteries are recommended).
5. Replace the battery cover and tighten
the screws to secure.
Remove Sunny’s protective cover by
pulling upwards.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
To Next Page
Loading...
Need help?
General