Configuration File Parameter Guide 126 Back to Contents
VCS754 Administrator and Provisioning Manual
"page_zone" Module: Paging Zone Settings
The paging zone settings allow you to define a maximum of 10 paging zones that the
VCS754 can use for multicast paging.
The paging zone parameters (except for page_zone.call_priority_threshold) follow the
format page_zone.x.[element], where x is the paging zone ID number, ranging from 1 to 10.
All the paging zone settings are included in the general configuration file.
Setting:
page_zone.x.name
Description: Sets the paging zone name, which appears on VCS754 LCD for outgoing
and incoming multicast pages. A maximum of 15 characters is allowed.
Values: Text string Default: Blank
Setting:
page_zone.x.multicast_address
Description: Enter the multicast IP address that the VCS754 will monitor. The range of
valid IP addresses is 224.0.0.0 to 239.255.255.255.
Values: IPv4 IP address Default: Blank
Setting:
page_zone.x.multicast_port
Description: Enter the multicast port associated with the multicast IP. The range of
valid ports is 1 to 65535.
Values: 1–65535 Default: Blank
Setting:
page_zone.x.accept_incoming_page
Description: Enables or disables the VCS754 from receiving incoming multicast
pages for that paging zone. If disabled, the VCS754 can make outgoing
multicast pages only.
Values: 0 (disabled), 1 (enabled) Default: 1
Setting:
page_zone.x.priority
Description: Set the paging zone priority from 1 to 10. Zones with a priority higher than
another zone can interrupt the lower-priority zone's active page.
Values: 1–10 Default: 5
To Next Page
Loading...
