Configuration File Parameter Guide 128 Back to Contents
VCS754 Administrator and Provisioning Manual
"softkey" Module: Custom Soft Key Settings
The custom soft key settings allow you to select which soft keys can appear on the Idle
screen, the Call Active screen, the Call Held screen and the Live Dial screen. You can also
specify the position of each soft key. Softkeys appear on the VCS754 screen in the same
order as the softkey values you enter. Enter soft key values separated by commas. For
more information, see “Customizing Soft Keys” on page 14. You can specify a maximum of
nine soft keys (three levels) for each parameter.
The soft key parameters follow the format softkey.[element].
Setting:
softkey.idle
Description: Specifies the soft keys visible on the idle screen.
Values: blank, dir, call_log, redial,
message, dnd, cfwd, cfna,
cfwd_all, cfwd_busy,
intercom, retrieve, callback,
grp_pickup, dir_pickup, line,
settings, pc_spk
Default: redial,line,pc_spk,call_log,
blank,dir
Setting:
softkey.call_active
Description: Specifies the soft keys visible on the active call screen.
Values: blank, new, park_call, end,
hold, transfer, conf, xferline,
confline
Default: end,transfer,conf,xferline,
confline
Setting:
softkey.call_held
Description: Specifies the soft keys visible on the held call screen.
Values: blank, new, park_call,
retrieve, grp_pickup,
dir_pickup, end, resume,
transfer, conf, xferline,
confline
Default: end,new,resume,transfer,
conf,xferline,confline
Setting:
softkey.live_dial
Description: Specifies the soft keys visible on the live dial screen.
Values: blank, dir, call_log, redial,
message, end, dial, input,
cancel, backspc
Default: backspc,input,dial
To Next Page
Loading...
