11
Getting started
Parent unit battery installation (continued)
To replace the battery, press down on the large tab of the battery and pull it
out of the battery compartment, then follow the steps on page 10 to install
the battery.
The operating time for using the rechargeable battery is short. If you want to
monitor your baby for a long time, we recommend you connect the parent unit
to AC power.
If the parent unit will not be used for a long time, disconnect and remove the
battery to prevent possible leakage.
Use only the battery supplied with this product. To purchase a replacement
battery, visit our website at www.vtechphones.com or call
1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call
1 (800) 267-7377.
•
•
•
To Next Page
Loading...
Need help?
General
