3
Getting started
Baby unit installation
Install the baby unit as shown below.
Make sure that the power outlet is not controlled by a wall switch. Bundle the
power cord neatly with the self-adhesive strap.
Use only the baby unit power adapters supplied with this product. To order a
replacement, visit our website at www.vtechphones.com or call
1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call
1 (800) 267-7377.
The baby unit power adapters are intended to be correctly oriented in a vertical
or floor mount position. The prongs are not designed to hold the plug in place if
it is plugged into a ceiling, under-the-table or cabinet outlet.
Make sure the baby units and the power adapter cords are out of reach
of children.
•
•
•
Baby unit
Power outlet not
controlled by a
wall switch
Baby unit
power adapter
Self-adhesive strap
Raise the antenna for
better reception.
To Next Page
Loading...
