15
Mount the baby unit on dry wall (optional)
Use a pencil and mark the position of two
holes to be drilled, making sure they are the
same distance apart as the wall mount holes
under the baby unit base.
Note
• Check for reception strength and camera
angle before drilling the holes.
Items to purchase
You will need to purchase the following
items separately to mount your baby unit:
2 screws
2 wall plugs
Adjust the camera angle.
Drill two holes in the wall. If you drill the holes
into a stud, go to step 3.
-OR-
If you drill the holes into an object other than
a stud, insert the wall plugs into the holes. Tap
gently on the ends with a hammer until the
wall plugs are flush with the wall.
Insert the screws into the holes and
tighten the screws until only 6.5 mm of
the screws are exposed.
Align the wall mount holes on the
baby unit with the screws on the wall.
Slide the baby unit down until it locks
into place.
Note
• The types of screws and wall plugs you need
depend on the composition of the wall.
To Next Page
Loading...
