23
MENU KEY
SELECT KEY
TIME/SET KEY
4. The OGM replays the message
automatically, followed by a beep.
5. To review a recorded announcement,
press MENU key until the desired
item (Set outgoing message) is
announced. Press any MAILBOX key.
The current greeting is played.
6. To delete a recorded announcement,
press DELETE during OGM playback.
Note: If your recording time is less than 2
seconds, your OGM will not be
recorded, and the default greeting will be
used.
Set Security Code
The security code programmed into the
ITAD is used to gain access to functions
from remote locations.
The security code default setting is 19.
1. Press MENU until you hear “Set
security code.”
2. Press TIME/SET to hear the current
security code.
3. Press SELECT briefly to increase the
security code by 1. Or, hold SELECT
continuously to increase the code by
multiples of 10.
4. Press TIME/SET to confirm your
choice and you will hear the
announcement of the security code.
Day and Time Setup
During initial setup, or after a power
failure, the day and time default is set to
Monday 12:00am. The display will flash
“CL” to indicate day and time need to be
set.
1. Press MENU until you hear, “Set day
and time.”
2. Press SELECT until the desired day
is announced.
3. Press TIME/SET to confirm your
choice.
4. Press SELECT until the desired hour
is announced.
5. Press TIME/SET to confirm your
choice.
6. Press SELECT until the desired
minute is announced. Holding the
key continuously will increase the
minute in 10 minute steps.
7. Press TIME/SET to confirm your
choice. You will hear the Day and
Time.
Set Audible Message Alert
If you want your ITAD to beep once ev-
ery 10 seconds to notify you when new
messages have been received, set the
Audible Message Alert to ON. Otherwise,
it is preset to OFF.
ITAD OPERATION
MENU KEY
SELECT KEY
TIME/SET KEY
To Next Page
Loading...
Need help?
General
