EasyManuals Logo

VTech VT 9151 User Manual

VTech VT 9151
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
30
Deleting Messages
1. Press “#9” once during message
playback to delete the current mes-
sage.
Note: Playback will pause if “#” or “*” is
entered. ITAD will wait for the command
in the following 2 seconds. If no further
tone is entered, playback will be re-
sumed.
Memo Recording
1. Press “*8”.
2. After selecting the mailbox by entering
command “1”, “2”, “3”, You will hear,
Now recording
”, followed by a beep.
3. Enter “#5” to stop recording when you
have finished.
Change OGM Remotely
1. Enter “*7” to record a new OGM. You
will hear, “Now recording” , followed
by a beep to signal start of recording.
2. Press “#5” to stop recording. Your
new OGM will playback automatically.
Check OGM Remotely
Enter “#7” to review OGM. You will hear
playback of OGM followed by a beep.
Turning ITAD ON or OFF
Pressing “#0” toggles the ITAD ON/OFF.
“Answer machine on”, or “Answer
machine off” will be announced, followed
by a beep.
REMOTE OPERATION OF ITAD
Voice Menu for Remote Operation
The system provides two pre-recorded
voice menus to help you during remote
operation. Press “*5” to go back to the
simple voice menu.
The simple voice menu is as follows:
Press “#1” to play mailbox 1.
Press “#2” to play mailbox 2.
Press “#3” to play mailbox 3.
Press “#5” to stop.
Press “#4” to repeat the message.
Press “#6” to skip the message.
Press “#9” to erase the message.
Press “*5” for other functions.
The advanced voice menu is as follows:
Press “#7” to review outgoing
message.
Press “*7” to record outgoing mes-
sage.
Press “*8” to record memo.
Press “#4” twice to repeat previous
message.
Press “#0” to turn the system on or
off.
Press “*5” to go back to the simple
voice menu.
Pressing any function code will stop the
voice menu, and perform the corre-
sponding functions.
Exiting Remote Operation
1. Enter “*0” to exit remote operation
mode. The ITAD confirms your action
with a long beep and then discon-
nects.
2. The ITAD also automatically discon-
nects if no key is pressed within 20
seconds during remote operation.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the VTech VT 9151 and is the answer not in the manual?

VTech VT 9151 Specifications

General IconGeneral
BrandVTech
ModelVT 9151
CategoryCordless Telephone
LanguageEnglish

Related product manuals