VTech VT 9151 - Page 39

44 pages

To Next Page

To Previous Page

VT 9151/VT 915

USER’S MANUAL

IMPORTANT

BEFORE USING YOUR NEW

PHONE, WE STRONGLY

RECOMMEND YOU READ THIS

MANUAL THOROUGHLY.

VTECH COMMUNICATIONS LTD.

900MHz CORDLESS ANSWERING SYSTEM

Main Page

Default Chapter1
- Table of Contents1
Introduction3
- Parts Check List4
Important Safety Instructions5
Replacing the Handset Batteries6
Getting Started8
Setting up Your VTECH VT 9151/VT 91558
Wall Mounting9
Handset Features10
- In Use/Low Batt Led10
- PHONE KEY / FLASH Function10
- Channel Key10
- Off Key10
- Mem Key10
- Prog Key10
- Redial Key10
- Tone / Key10
- Volume Control10
Base Unit Features11
- Power Led11
- Charge Led11
- In Use Led11
- Spare Battery Led11
- Page Key11
- Base Unit Display12
Operating Instructions13
- Making Calls13
- Answering Calls13
- Disconnecting13
- Changing Channels13
- TONE/ PULSE Setting13
- Temporary Tone14
- Programming the Ringer Type14
- Turning off the Ringer14
- Checking the Ringer14
- Memory Dialing15
- Programming Speed Dial Numbers15
- Speed Number Dialing15
- To Change or Replace a Speed Dial Number15
- To Clear the Stored Number15
- Storing Special Codes16
- Using Redial16
- Storing a Redial Number into Speed Dial16
- The Page Feature16
Itad Base Leds17
- MAILBOX Led's17
- Answer On/Off Led17
Itad Base Keypad Functions18
- Answer On/Off Key18
- MAILBOX X (1,2 or 3) KEY18
- Rec/Memo Key18
- Menu Key19
- Select Key19
- Time/Set Key20
- Delete Key20
- Repeat/Slow Key20
- Skip/Quick Key21
- Volume up Key21
- Volume down Key21
Itad Operation22
- Default ITAD Settings22
- ITAD Programming Overview22
- Selecting Announcement22
- Recording / Playing / Deleting the Ogm's22
- Set Security Code23
- Day and Time Setup23
- Set Audible Message Alert23
- Set Announce Only24
- Set Base Ringer ON/OFF24
- Set Number of Rings24
- Leaving a Message (Incoming Message)25
- Listening to Messages / Memos25
- Saving Messages26
- Deleting Messages26
- Turning the ITAD ON/OFF26
- Call Screening27
- Audible Current Day and Time27
- Changing Speaker Volume27
- Changing Playback Speed28
- Auto Disconnect for Extension Phone Pick-Up28
- Memory Full28
- Power Failure28
Remote Operation of Itad29
- To Activate Remote Operation from a Different Telephone Line29
- Playing Messages Remotely29
- Repeat Messages During Playback29
- Skip Messages During Playback29
- Stop Message Playback29
- Deleting Messages30
- Memo Recording30
- Change OGM Remotely30
- Check OGM Remotely30
- Turning ITAD on or off30
- Voice Menu for Remote Operation30
- Exiting Remote Operation30
Optional Headset Installation and Operating Instructions31
Maintenance32
In Case of Difficulty33
Warranty Statement34
Fcc and IC Regulations35
Technical Specifications37

VTech VT 9151 - Page 39

Table of Contents

Related product manuals