VTech VT1047 - Find the Handset; Make an Internal Call

15
4.9 Find the Handset
You can locate the handset by pressing P on the base station. All the handsets registered to the base will produce
the paging tone and "PAGING" is displayed on the LCD. You can stop the paging by pressing
T / F / C on any
handset or
P on the base again.
Note:
If there is an incoming call during paging, the phone will ring with the incoming call instead of paging.
4.10 Make an Internal Call (For VT1047-2)
This feature is only applicable when there are at least two registered handsets. It allows you to make internal calls,
transfer external calls from one handset to another handset and make conference calls. If the called handset is not
answered within 60 seconds, the called handset will stop ringing and the calling handset will return to standby mode.
Note:
If only one handset is registered to the base station, press
C will display "NOT POSSIBLE".
4.10.1 Intercom Another Handset
1. In idle mode, press C and the registered handsets will display except the calling handset.
2. Enter the desired handset number to intercom with.
3. The called handset rings and press
T on the called handset to establish the internal call.
Note:
If two handsets are registered to the base station, press
C will connect to another handset immediately.
4.10.2 Call All Handsets
1. In idle mode, press C and the registered handsets will display.
2. Press
9 to ring to all registered handsets.