Phone settings
30
Note:
If the new PIN entered in Step 6 is not matched with the new system PIN entered in Step 5, user is requested to enter
the valid system PIN again in Step 5.
7. Press
M to confirm.
7.4.5 ECO Mode Setting
1. Press M and +/- to select BS SETTINGS.
2. Press
M and +/- to select ECO MODE.
3. Press
M and +/- to select ON or OFF.
4. Press
M to confirm.
7.5 Registration
Your handset and base station is pre-registered. Up to five handsets can be registered to a single base station.
If for some reason, the handset is not registered to the base station ( flashes even when the handset is near the
base station), register your handset according to the following procedure.
1. Press and hold
P on the base station for about five seconds, the base station is entered into registration mode.
2. Press
M and +/- to select REGISTRATION.
3. Press
M and you are requested to enter the 4-digit system PIN. (Default is 0000)
4. Enter the 4-digit system PIN.
5. Press
M to confirm.
If the handset registration is successful, the will stop flashing. The handset will automatically be allocated the next
available handset number. This handset number is shown in the handset display in standby mode. If the handset
registration is unsuccessful, the will still flash.
To Next Page
Loading...
Need help?
General
