VTech VT1047 - Change the Dial Mode; Change the Flash Time; Change the System PIN Code

29
7.4.2 Change the dial mode
1. Press M and +/- to select BS SETTINGS.
2. Press
M and +/- to select DIAL MODE.
3. Press
M and +/- to select TONE or PULSE.
4. Press
M to confirm.
7.4.3 Change the Flash Time
The flash time settings is country dependent. Please contact your local service provider for the correct settings.
1. Press
M and +/- to select BS SETTINGS.
2. Press
M and +/- to select FLASH TIME.
3. Press
M and +/- to select your desired flash time (SHORT, MEDIUM, LONG).
4. Press
M to confirm.
7.4.4 Change the System PIN Code
A 4-digit system PIN code is used for changing the system settings of the base station. It is used to protect your phone
against unauthorized use. The default system PIN code is 0000.
1. Press
M and +/- to select BS SETTINGS.
2. Press
M and +/- to select CHANGE PIN.
3. Press
M and you are requested to enter the 4-digit system PIN.
4. Enter the old system PIN.
5. Press
M and enter the new system PIN.
6. Press
M and enter the new system PIN again.