5.Product Operating Instructions
5.1 Power & Function On/Off
1.Power On: Short press any button to power on the product
and enter the standby state, the LCD Screen will light up and the
battery level indicator icon will display.
2.Power Off: Turn off all outputs manually, then the product
enters the standby state and will shut down after 30 minutes.
3.AC Output On/Off: Short press the AC Button to use the AC
output; Short press the AC Button again to turn if off.
4.DC Output On/Off: Short press the DC Button to use the 12V
DC output; Short press the DC Button again to turn if off.
5.USB-A & USB-C On/Off: Short press the USB Button to use
the USB-A & USB-C output; Short press the USB Button again to
turn if off.
6
Warm Tips:
2.V-Beyond Technology: It allows you to run devices over 600
watts but no more than 1200 watts on Jump 600X power station.
It would lower the output voltage to bring the power back down
without tripping the overload protection, so that yo can continue
to run those devices. It's suitable for resistive loads such as lights,
space heaters, toasters, ovens, and coffee makers, etc. But please
note that it's NOT suitable for complex electronics such as com-
puters, TVs, refrigerators, etc.
1.Auto Shut-off Feature: When any output switch of the battery
is turned on, the battery will maintain continuous output for 6
hours. After 6 hours, the battery starts to detect the load current
and lasts for 2 hours. There are three situations as follows:
1) If no load is detected within 2 hours, the battery will automat
ically shut down;
2) When the load is detected within 2 hours, the battery will
continue to output;
3) If it is detected that the load is turned on and then turned off
within 2 hours, the load detection will be restarted for 2 hours
after the load is turned off.
To Next Page
Loading...
