5 System ON/OFF
Before starting the system:
1. Please make sure all cables are reliably connected and securely fastened;
2. Please make sure the system is properly grounded;
3. Please make sure the power switch of the display cube is in ON status;
4. Please make sure the lens cover is removed.
Startup Steps:
1. Turn on the power switch of the signal system and input signal;
2. Turn on the power supply of the multi-screen processor;
3. Turn on the power supply of the PC running VWAS;
4. When the multi-screen processor completes its self-detection, start the control
system software on the PC and start the display cubes with the control system
software.
Note:
1. Turn on the display cube after it has been powered up for one minute;
2. It will take some time for the display cube to display any content after startup. Do
not repeatedly press the POWER button in the control software.
Shutdown Steps:
1. Shut down the multi-screen processor and turn off its power switch when the
prompt for safe shutdown appears.
2. Shut down the display cubes with control software on PC and then shut down the
PC.
3. Turn off the power switch of interface box when the fan of projector stops.
Note: Any forced power-off may cause damage to the system.
Warning
The system commissioning and parameter adjustment can only be performed by trained
and qualified professionals.
To Next Page
Loading...