Vuly Quest - Page 18

18
Repeat Steps 16-19 to complete the other side of your outer section.
Slide the Long Side Rail and Short Side Rail into the
Top Rails above the climbing bars, as indicated for your
model.
A. Slide a Flip Rail into one end of
an Angled Joiner, and a Flip Tube
into the other. Insert a Foot into the
bottom.
B. Repeat for the 3 remaining Flip Rails,
Angled Joiners, Flip Tubes and Feet.
A.
If you are installing a
Flying Fox attachment.
Position your Flying Fox
Rail and connectors
here.
B.
Important: Ensure that your frame matches the below –
particularly the Shade Tubes.
WARNING: Do not force any part
too far into the Angled Joiner. This
will block the part on the other side
from connecting completely.
EXTRA LARGE
21
STEP
ALL SIZES
23
STEP
LARGE AND EXTRA LARGE
22
STEP