1
PACKAGE
CONTENTS
Incubating Mini Shaker or Incubating Microplate Shaker
234cm detachable power cord
Instruction manual
INSTALLATION
Upon receiving the VWR Incubating Mini/Microplate Shaker, check to
ensure that no damage has occurred during shipment. It is important
that any damage that occurred in transport is detected at the time
of unpacking. If you do find such damage the carrier must be notified
immediately.
After unpacking, place the Incubating Mini/Microplate Shaker on a
level bench or table, away from explosive vapors. Secure to an
immovable work surface by pressing down on the four (4) corners of
the unit, creating a strong suction to the work surface (DO NOT place
on a bench mat). Ensure that the surface on which the unit is placed
will withstand typical heat produced by the unit. Always place the
unit on a sturdy work surface.
The Incubating Mini/Microplate Shaker is supplied with a power cord
that is inserted into the IEC connector on the back of the unit first,
then it can be plugged into a properly grounded outlet. The 230V
unit plugs into a 230 volt, 50/60 Hz source.
TABLE OF
CONTENTS
Package Contents . . . . . . . . . . . . 1
Installation . . . . . . . . . . . . 1
Maintenance & Servicing . . . . . . . . . . . . 2
Environmental Conditions . . . . . . . . . . . . 2
Intended Use . . . . . . . . . . . . 2
Equipment Disposal . . . . . . . . . . . . 2
Safety Instructions . . . . . . . . . . . . 3
Standards & Regulations . . . . . . . . . . . . 3
Control Panel . . . . . . . . . . . . 4
Incubating Mini Shaker . . . . . . . . . . . . 5-6
Incubating Microplate Shaker . . . . . . . . . . . . 7-8
Operating Instructions . . . . . . . . . . . . 9-10
Troubleshooting . . . . . . . . . . . . 11
Replacement Parts . . . . . . . . . . . . 12-13
Accessories . . . . . . . . . . . . 14
To Next Page
Loading...
