Need help?Do you have a question about the VWR CO2 Incubator Basic and is the answer not in the manual?
General| Brand | VWR |
|---|---|
| Model | CO2 Incubator Basic |
| Category | Accessories |
| Language | English |
Details operating personnel responsibilities, safety data sheets, and technical regulations for safe incubator use.
Outlines VWR warranty conditions and defines symbols and signal words used in the instructions.
Provides key safety information regarding CO2 hazards, personnel instructions, overpressure, and pressure compensation openings.
Specifies CO2 gas quality requirements, access port usage, and health/contamination hazard warnings.
Warns about incompatible cleaning agents, specifies water quality, and details risks of alcoholic disinfectants.
Defines the device's intended use, lists prohibited uses, and outlines compliance standards and directives.
Details operating environment requirements like altitude, temperature, humidity, and mains voltage fluctuations.
Describes packaging materials, lists standard equipment, and instructs on acceptance inspection.
Specifies required ambient conditions for operation, including draft-free location and sufficient room ventilation.
Details necessary clearances around the device, floor stand requirements, and safe transport instructions.
Illustrates device components and lists installed safety features like door switch and thermal protection.
Explains how temperature, humidity, and CO2 control simulate physiological conditions and details the sensor system.
Describes the switchbox, supply interfaces, gas connection, RS 232 interface, and alarm contact.
Details the stainless steel internal chamber, water reservoir, heating system, and the shelf system configuration.
Guides on preparing the work space, installing shelves, levelling, and connecting gas and power.
Explains the function and operation of the power switch and the features of the device's operating panel.
Provides step-by-step instructions for setting the nominal temperature and CO2 values on the operating panel.
Details activating the auto-start routine, canceling routines, and reading/interpreting failure codes.
Outlines decontamination procedures, including wipe/spray disinfection and 90°C routine.
Lists daily, annual, and interval checks, including refilling water tray and running auto-start routine.
Explains preparation and procedures for temperature and CO2 comparison measurements and calibration.
Provides instructions for replacing particle filters, device fuses, and the door seal.
Provides contact information for technical support and requirements for ordering parts and accessories.
Lists mechanical, thermal, humidity, gas supply, CO2 cell, electrical, and other system specifications.
Warns about contamination hazards during disposal and lists device components and their materials for recycling.
Instructs on recording nameplate information, work performed, maintenance, and repairs in the device log.
Provides a template for a certificate of decontamination, including works performed and declarations.
To Next Page
