VWR CO2 Incubator Basic - Device Log and Certification; Device Log Recording

VWR CO2 Incubator Basic | 77
Disposal
CAUTION
Contamination hazard:
The device can be used for preparing and processing infectious substances so that the device or
device components may become contaminated.
Before device components are discarded, they must be decontaminated!
 The device components must be cleaned thoroughly; after the cleaning, they must be
disinfected or sterilized, as required by the application.
 Discarded devices or device components must be provided with an appropriate certificate
showing the decontamination measures performed!
All device components can be discarded properly after they have been decontaminated properly.
NOTE!
Recycling service:
VWR offer, for a small fee, an environmentally compatible recycling service for discarded devices!
List of used materials:
Component Material
Thermal insulation components Polystyrene foam EPS/PPS-Compound
Printed circuit boards Enclosed electrical components coated with different
plastics, equipped on epoxy resin-bound boards.
Plastic components, general Note material labeling
Exterior housing Galvanized steel sheet, painted
Device rear panel Galvanized steel sheet
Outer door Galvanized steel sheet, painted
Door inner panel Galvanized steel sheet, painted
Operating panel housing and protective foil Polyethylene
Magnetic door seal Magnetic core sheathed with EMPP
Heating Silicone-sheathed resistance-type wires