VWR CO2 Incubator Basic - Chapter 6 Operation; Preparing the Device

VWR CO2 Incubator Basic | 39
Operation
Preparing the device
The device must only be released for operation after all major measures for the start-up have
been taken (see Chapter 5 “Start-up”).
Prior to starting operation, the following device components must be checked for their correct
function:
 Gas hoses must be seated tight on the connecting filter and must be secured using a hose
clamp.
 The access port must be capped.
 The pressure compensation opening must be permeable, its insert must be installed in the
work space.
 The glass door seal must not be damaged.
 The glass door measurement opening must be capped.
 The shelf system components must be installed safely.
NOTE!
Hygiene regulations:
Prior to any operation, the user must clean and disinfect the work space in accordance with the
hygiene regulations set forth by the operator to protect the cultures.
Water supply:
The water tray of the work space can hold up to 3.0 l of processed water. When the running
operation, always keep a sufficient quantity of processed water of the following quality available:
 Demineralized and distilled or autoclaved for sterilization
or
 Completely deionized and distilled or autoclaved for sterilization
When the water level falls below the lower limit, refill water!