VWR CO2 Incubator Basic | 51
Shut-down
Shutting the device down
WARNING
Contamination hazard:
If the work space surfaces are contaminated, germs my be transferred to the environment of the
device.
In case of a shut-down, the device must be decontaminated!
1. Remove culture containers and all accessories from the work space.
2. Pump water out off the water reservoir.
3. Clean and decontaminate the work space and wipe device dry.
Turn device off using the power switch
4. Unplug power connector and protect it against accidental reconnection.
5. Close the CO
2
supply system shut-off valves.
6. Disconnect gas pressure hoses from sleeve at the rear of the device.
7. Until the device is shut down, the work space must be continuously ventilated: Leave the glass
door and the outer door open and secure them in this state.
To Next Page
Loading...
