(4) microplates(2) microplates (2) Micro-Tube Racks
INCUBATING
MICROPLATE SHAKER SET-UP
The Incubating Microplate Shaker is designed to hold two (2) or four (4) microplates, or two (2) Micro-Tube Racks.
1. Place two (2) microplates or deep well blocks diagonally on the tray, or place four (4) microplates or deep well blocks on the tray. The
plates/blocks do not have to be filled.
2. Place the corner of the plate/block under the spring located at each corner of the tray.
3. Slide plate/block into place. You are ready to use.
8
INCUBATING MICROPLATE SHAKER TRAY CONFIGURATIONS
2. 3. 4.
NO
TE: The tray on the Incubating Microplate Shaker is not designed to hold flask clamps.
To Next Page
Loading...
