- 8 -
2.5. BALANCE LEVELING
It is necessary to level the balance prior to plugging it in. To level the balance, turn its feet until
the air bubble is in the center position.
The balance should firmly rest on a surface, each of the feet must be supported.
2.6. POWERING THE DEVICE
Balance can be connected to the mains only with a power adapter that comes standard with the
particular model. Nominal power supply of the power adapter (specified on the power adapter data
plate) should be compatible to the power from the mains.
Plug the balance to the mains – connect the power adapter to the socket, next connect its connector
to port located at the back of the balance housing.
Test of the display unit takes place right after connecting the balance to the power, all the elements
and pictograms are backlit for a short time. Next, the name and the program number appears (please
note, software version number may be different than what appears below)
The indication then goes to ZERO (displayed reading unit depends on the balance). If the indication
is different than zero, please press
button.
To Next Page
Loading...
