5.7 Parameters checking
Hold for 3 seconds to enter the real running data checking.
Press and to check below parameters , press to check the data of selected parameter,
press again to return back. Press to return back the main interface.
Return water temp. difference
Desired water temp. under cooling
Desired water temp. under heating
High exhaust temp. protection value
Exhaust temp. recovery value
Compressor current protection value
Inlet water temp. compensation
Accumulated running time of Compressor
Piping temp. of enter defrosting
Piping temp. of exit defrosting
Difference of ambient temp. and piping temp.
Ambient temp. of enter defrosting
ATTENTION!
The logic of Inverter pool heat pump is much more complicated than the traditional ON/OFF system, we do
advise not to adjust the key parameters which may affect the reliable operation of the unit.
5.8 Manual defrosting
When piping temp. Is lower than Parameter P12, hold and for 3 seconds to enter Manual
defrosting function.
To Next Page
Loading...
