Page 5
Step 11
Plug the power cord into a
grounded electrical outlet.
NOTE: FOR OPTIMAL SAFETY,
A SURGE PROTECTOR
SHOULD BE USED (NOT
SUPPLIED WITH THIS
ADJUSTABLE BED).
Step 10
Insert the mattress
retainer into the
base. Look under
the base and make
sure the are no cords
interfering with base
mechanism.
PAIR BUTTON
Connecting Straps
If you are installing two split bases together, you will receive two hook and look
straps with the accessories (one with each base). As optional step, you can loop
these straps around the top and bottom legs that are closer to next base legs to
help in preventing separation or gaps between the bases. Fasten straps tightly as
shown on the diagram and image on the right.
NOTE: If your base has push button type adjustable legs, AVOID looping the
strap over a push button to prevent leg misalignment.
Step 12 - Connecting straps (Split Sizes Only) - Optional installation
Use if you are setting up two Twin XL bases to use with one King size mattress, or when setting up two parts of Split California King base
model with one Cal-King mattress.
Remote pairing
Commonly, your remote control will be already paired with your base from the factory, however, if you need to replace your remote or need to
re-pair current remote. Please follow these steps:
1. Press and hold pair buttons on remote control. The pair
buttons vary depending on the model, pairing buttons for
each model are marked with green on the right.
2.While still holding pairing buttons on the
remote, press “PAIR” button which is located
in the control box cable, close to the connection
to power supply unit (do not confuse pair button
with red button on power supply).
3. When pairing is complete, you will hear a
beep, if no beep is heard, repeat steps 1 and 2
with a rmer press on remote’s buttons before
pressing “PAIR” (cable) button.
G72
Remote
Step 9
For safety reasons, the following step should be performed by
two people. Lift and rotate the bed to its nal position, holding
the metal frame.WARNING: DO NOT LEAN THE WEIGHT OF
THE BASE AGAINST THE SIDE OF THE LEGS, DOING SO MAY
RESULT IN PERSONAL INJURY AND PRODUCT DAMAGE.