EasyManua.ls Logo

WACKER Group PT 6LT - Basic Troubleshooting

WACKER Group PT 6LT
66 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance PT 6 /...
wc_tx000567gb.fm 50
5.28 Basic Troubleshooting
Problem / Symptom Reason / Remedy
Engine does not start. Fuel tank empty.
Wrong type of fuel.
Old fuel. Drain tank, change fuel filter, and fill with
fresh fuel.
Fuel system not primed.
Battery connections loose or corroded. Battery
dead. Electrolyte low.
Engine oil level low.
Engine hot.
Ignition switch defective.
Throttle solenoid defective.
Electrical connections loose or broken.
Engine faulty.
Engine is hard to start. Dirt or debris inside pump housing blocking move-
ment of impeller.
Battery charge low.
Engine faulty.
Engine starts but pump does
not take in water.
Pump housing not filled with water.
Strainer on suction hose plugged.
Suction hose damaged. Air leak above water line.
Air leak at suction port.
Pump too high above water line.
Engine speed too low.
Debris collecting in pump housing.
Pump takes in water but little
or no discharge.
Suction strainer partially plugged.
Impeller worn. Shim insert.
Discharge hose kinked or blocked.
Engine speed too low.
Engines stops by itself. No fuel.
Engine oil pressure low.
Engine too hot.