6-8 OM 25-3503 us – Edition 4.1 * * 2503_3503b610.fm
Technical datac
•Fill up ditches and holes.
•Provide a machine and enough time to keep the job site in good condition.
• Use an operator seat according to the ISO 7096 requirements. Keep the operator seat
in good condition and adjust it correctly:
•Adjust the operator seat and suspension to the operator’s weight and size.
•Check and maintain the seat adjustment and suspension.
• Perform the following activities smoothly without any jerks.
•Steering
•Braking
•Acceleration
•Shifting gears
• Move attachments without any jerks.
• Adapt your speed and the itinerary to minimize vibration:
•Travel around obstacles and uneven ground.
•Reduce your speed during machine travel across rough terrain.
• Reduce vibration to a minimum during long work cycles or during machine operation
over long distances:
•Use a machine with a suspension system (for example on the operator seat).
•Enable the hydraulic oscillation damping if the machine is equipped with
tracks.
•If the machine is not equipped with hydraulic oscillation damping, reduce your
speed to avoid bumps and jolts.
•Load the machine on a truck or trailer to move between job sites.
• Other risk factors can affect drive comfort negatively. The following measures can
improve drive comfort:
•Adjust the operator seat and the control elements to a relaxed body posture.
•Adjust the rearview mirrors to ensure optimal visibility so you can adopt an
upright seating position.
•Provide breaks to avoid sitting for long periods.
•Do not jump off the cabin.
•Picking up and raising loads repeatedly must be limited to a minimum.
To Next Page
Loading...
Need help?
General
