OM 25-3503 us – Edition 4.1 * 2503_3503b210_us.fm 2-9
Safety instructions
Shatter protection (Option)
The optional shatter protection protects the operator against material falling from the front.
DANGER
Stabbing/puncture/crushing hazard from falling objects
(fragments or splinters) projected from front of machine.
Objects will cause serious or deadly injuries.
• When working in areas with a risk of falling or projected objects, an operator
safety shield must be installed (option equipment).
• Machine operation is prohibited under these conditions without the operator
safety shield installed.
WARNINGW
Personal injury hazard! Do not modify the shatter protection.
Failure to follow this precautionary measure can lead to severe injury or death.
• No drilling, cutting or grinding.
• Do not mount any brackets.
• Do not perform any welding/bonding work.
• Replace the complete protective structure if it is damaged, deformed and/or
cracked.
• If you are not sure, always contact a Wacker Neuson dealer.
• Repair work may be performed by a Wacker Neuson dealer only.
Do not use brushes, steel wool or other abrasive cleaners for cleaning the
polycarbonate disc. Do not wipe dust in a dry state.
Work range and restricted visibility
WARNINGW
Accident hazard! The size of the work range depends on the
attachment used.
Risk of injury.
• – see Operator’s Manual of attachment
– see example: work range with hydraulic hammer Fig. 72
• Do not use the attachment outside the defined work range.
NOTICE
Stop working when visibility is restricted due to rain, snowfall, dust etc.
☞ Resume work only if visibility is no longer restricted.
0°
Fig. 72: Example: work range with hydraulic hammer
To Next Page
Loading...
Need help?
General
