Safety information
SV00075en.fm 10
2.3 Safety checks
2.3.1 Floor saws may only be operated with all safety devices installed.
2.3.2 Before starting operation, the operator has to check that all control and
safety devices are functioning properly.
2.3.3 Prior to starting the cutting operation, the following have to be checked
on a daily basis:
∗ Proper condition of the cutting blade.
∗ Tightness of the cutting blade.
∗ Damage and wear of the operating and safety equipment.
2.3.4 If defects on the safety devices or other defects impairing the
operational safety of machine are observed, the supervisor must be
informed immediately.
2.3.5 If there are defects jeopardizing operational safety, the machine has to
be switched off immediately.
To Next Page
Loading...
