T01110en.fm 17
Operation
6. Operation
6.1 Adjusting the handle
6.1.1 Handle
The width and height of the handles can be adjusted according to the
use and the body height of the operator. To do this, release the
clamping lever (1) and apply it in the new position.
6.1.1 Stirrup handle (alternative version)
The height of the stirrup handle can be adjusted according to the use
and the body height of the operator.
Loosen the knurled screws (1) on both sides, swivel the handle to the
desired position and retighten the two knurled screws.
To Next Page
Loading...
