Wacker Neuson BS 70-2i

Operation BS 60-2i, BS 70-2i
28 wc_tx000919gb.fm
5.4 Before Starting
5.4.1 Read safety instructions at the beginning of this manual.
5.4.2 Make sure that the gas tank is full, and that the oil tank is at least ¼ full.
5.4.3 Place rammer on loose soil or gravel. DO NOT start rammer on hard
surfaces such as asphalt or concrete.
5.5 Starting
See Graphic: wc_gr007362
5.5.1 Set the throttle to the idle position (c2). This will automatically turn on
the flow of fuel.
5.5.2 Close the choke (b1).
5.5.3
Pump the purge bulb (e) 6 to 10 times or until you see fuel in the bulb.
Note: The engine will not become flooded by pumping the purge bulb
more than 10 times. Pumping the purge bulb removes air from the fuel
system. It does not pump fuel into the carburetor.
5.5.4 Pull starter rope. Repeat until engine starts.
Multiple pulls (typically less than 5 pulls) may be required to start an
engine:
• that has not been run before.
• that has not been run for a long period of time (a week or more.)
• that has been run completely out of fuel.
• in cold weather conditions.
5.5.5 Open the throttle to the full position (c3). The choke will open
automatically.
Note: The engine is equipped with a low oil level shutoff switch. If the
engine stops running after 15-30 seconds, check the oil level in the oil
tank and add Wacker Neuson two-cycle oil or equivalent as necessary.