Operation BS 600/BS 700
wc_tx000023gb.fm 24
5.5 To Stop
See Graphic: wc_gr000053
5.5.1 Place throttle in the idle position (c2).
5.5.2 Shut off the engine by moving the throttle through the detent to the off
position (c1). The engine will stop and the fuel valve will close.
Note: If the throttle control wire should break, shut off the rammer
manually by using the engine STOP button (d).
5.6 Operation
See Graphic: wc_gr000044
Keep vibratory rammer clean and dry. Avoid no-load strokes. Never
allow the rammer to run full throttle when forcing away material or
when lifting the equipment.
CAUTION: To prevent damage to the rammer, do not allow the
rammer to run on its side.
If the rammer should tip on its side, place the rammer in the position
shown, then shut off the engine by moving the throttle control lever
through the detent to the off position.
To Next Page
Loading...
Need help?
General
