9 Operation and use
100_0201_op_0001.fm 21
1. Hold the machine firmly by the control handle with your left hand.
2. Choke ON.
3. Actuate the gas throttle lever - half-throttle position.
4. Slowly pull the starter rope out until you feel compression resistance and allow it to roll back in slowly.
5. Pull out the starter rope forcibly, but not in a jerky manner.
Slowly allow the starter rope to reel in again.
6. Put the choke at half position when the first ignition of the engine can be heard.
7. Forcibly pull out the starter rope, but not in a jerky manner, until the engine has started.
Slowly allow the starter rope to reel in again.
8. Push the gas throttle lever back - idle position.
9. Allow the engine to warm up.
10.Choke OFF after 20-30 seconds.
9.5 Operation
Only guide and steer the machine using the control handle.
9.5.1 Compacting material
1. Guide the machine with both hands on the control handle.
2. Actuate the throttle lever until the desired rpm is reached.
3. Once the material is compacted, raise the machine and relocate.
When lifting the machine, place the gas throttle lever to the idle position so that the engine will
continue to run at a low rpm.
9.6 Decommissioning
1. Push back the gas throttle lever.
2. Hold down the off switch until the machine has come to a complete stop.
3. Close the fuel cock.
NOTICE
To start the engine, remove the engine at least 3 m from the refueling point.
WARNING
Injuries from uncontrolled and unguided machines.
Always hold the machine with both hands and assume a secure stance.
Item Designation Item Designation
1 Off button 3 Gas throttle lever
2 Fuel cock
NOTICE
Park the machine so that it cannot tip over, fall or slip away.
To Next Page
Loading...
Need help?
General
