T01126en.fm 41
Starting up
7. Starting up
NOTICE:
Before working on the cut-off saw, always turn off the en-
gine, pull off the spark plug connector and wear protective
gloves!
NOTICE:
The cut-off saw must not be started until it has been com-
pletely assembled and tested!
Always use the assembly tools included in delivery for the following
procedures:
1 Combination wrench 13/19 mm
2 Offset screwdriver
3 Screwdriver for setting the carburetor
4 Adapter ring (not usually included in delivery)
NOTE: Only for the BTS 1140L3 model
No air cleaner mounted!
Before starting operation, insert the oiled foam air cleaner (prefil-
ter) as shown in illustration 31! First remove the filter cover (see
chapter Cleaning/Changing the air cleaner).
Knead the foam air cleaner in the packaging prior insertion to ensure
distribution of the oil. Remove the packaging afterwards.
30
31
To Next Page
Loading...
Need help?
General
